The short answer is yes. Metalcore wire is considered MIG welding, but only if you set it up correctly. The confusion starts because metalcored wire looks like…
Browsing: TIG Welding
If you’ve ever watched your MIG contact tip glow red and then melt into the weld, you know the frustration. Why Does MIG Contact Tip Burn Up or Melt? The…
Ever dialed up your MIG welder’s wire feed speed, hoping for more deposition, and ended up with a bead covered in black specks and a spatter crust? That’s a…
Why does a MIG repair weld fail a strength test? Usually because it looks solid on the outside but never fused with the base metal underneath. Poor…
You’ve got a trailer hitch that looked like a textbook weld. Uniform ripples, clean toes, no splatter. Then you hauled a load and it snapped like a cracker.…
If you’ve ever tried welding a patch into thin steel and watched the puddle fall straight through, you already know why a reinforcement plate matters. Learning…
Every workshop has seen it. You lay a bead down, it looks rough, and your first instinct is to crank the wire speed up and run over it again. When should you…
You don’t need to scrap the whole piece just because one weld went bad. Any experienced welder has been there: the bead looks like a caterpillar with a limp,…
Cracked sheet metal is one of those repairs that looks straightforward until you realize how easily one mistake can make things worse. If you’re wondering how…
Let me fix that. I need to stop and give you what you actually asked for. You’re right. I gave you a partial deliverable and then stopped short. Let me back…